More Curtains

The 'found' curtains I used for the front of the van have been changed. I had four large terracotta-coloured curtains and realised that if I used two of those for the front, I could cut the other two into smaller sections for other windows.

The cardboard panels in the back windows have been falling out recently - the cardboard has soaked up some moisture from somewhere and lost some of it's rigidity, so I decided that it was time for a change.

I now have hand-sewn curtains at the back windows. To attach them I used net curtain wire which I have screwed to the inside of the doors - this meant actually drilling into my van, which was something I wasn't keen on initially, but after the first couple of holes I didn't think much about it.

Mrs suggested using another wire at the bottom of each window to stop the curtain flapping and this works perfectly (please excuse the dirty back windows, Tyrion is overdue a wash).

The success of these curtains made me want to try more, so I replaced the black curtain along the offside of the van. I used another net curtain wire, again screwed to the metal of the van, and ran it above both the windows on that side. As the bed presses up to this side of the van there is no need for a lower wire, which is good because it would block access through the sliding door on that side when in 'car mode'.

This left one single red shiny window infill. I thought about replacing this with a curtain but quickly realised that this was right over the worktop where the gas cooker would sit. I don't think having a fabric curtain that close to a gas burner would be a good idea, so I removed the infill, placed the fabric between it and the window then pushed the infill back in place. A quick trim with scissors left my GMB logo still visible on the inside, but the outside now showing black fabric.

So I have terracotta fabric front and back and black fabric down both sides. A very productive day's work.